Hardware
Platform
Small sensor.
Big structures.
We designed the Asense IMU to measure structural movements too small for most sensors.
Hardware you
can measure.
Data Pipeline.
Edge-to-Cloud Telemetry.
1// Hardware Interrupt2void on_motion_event() {3 analog_read(SENSOR_AXIS_X);4 analog_read(SENSOR_AXIS_Y);5 analog_read(SENSOR_AXIS_Z);67 // 50Hz sampling achieved8}
Sampling Rate
Samples fast enough to capture short vibration events.
Resolution
Very sensitive accelerometer for precise tilt and displacement.
Ingress Protection
Sealed enclosure that withstands dust, rain and salt air.
Connectivity
Sends data straight to the cloud over LTE-M or NB-IoT. No gateway needed.
TDK InvenSense sensor.
InvenSense 6-Axis IMUSmartIndustrial™
Each node uses a TDK InvenSense MEMS motion sensor that we calibrate ourselves. It measures acceleration and tilt on three axes, to less than a milliradian.
Processing on the sensor
An ARM Cortex-M0 processor next to the sensor analyses the data before sending it. Less data is sent, and the node uses very little power.
Industrial Resilience
The whole module sits in an IP65 enclosure. It is protected against dust and water jets, for use on busy construction sites.
The Edge Node.
Mounts anywhere
Mount it on fencing or concrete piers. It needs no power cable or network.
Long battery life
Runs on solar power, with an internal lithium-thionyl chloride battery that lasts up to 8 years.
Built-in LTE-M
Connects securely to the cloud as soon as it is switched on. No site Wi-Fi or gateway needed.